HP A8800 Configuration Manual page 453

Device
Source 2
Receiver 1
Receiver 2
Configuration procedure
1. Enable IPv6 forwarding on each router, and assign the IPv6 address and prefix length to each
interface as per
2. Configure OSPFv3 on the routers in the IPv6 BIDIR-PIM domain to ensure network-layer
reachability among them. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM, IPv6 BIDIR-PIM, and MLD:
# On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable
IPv6 BIDIR-PIM.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] pim ipv6 sm
[RouterA-GigabitEthernet3/1/1] quit
[RouterA] interface Serial 2/1/9/1:0
[RouterA-Serial2/1/9/1:0] pim ipv6 sm
[RouterA-Serial2/1/9/1:0] quit
[RouterA] pim ipv6
[RouterA-pim6] bidir-pim enable
[RouterA-pim6] quit
# On Router B, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, enable MLD
on interface GigabitEthernet 3/1/1, and enable IPv6 BIDIR-PIM.
<RouterB> system-view
[RouterB] multicast ipv6routing-enable
[RouterB] interface GigabitEthernet 3/1/1
[RouterB-GigabitEthernet3/1/1] mld enable
[RouterB-GigabitEthernet3/1/1] pim ipv6 sm
[RouterB-GigabitEthernet3/1/1] quit
[RouterB] interface Serial 2/1/9/1:0
[RouterB-Serial2/1/9/1:0] pim ipv6 sm
[RouterB-Serial2/1/9/1:0] quit
[RouterB] interface Serial 2/1/9/2:0
[RouterB-Serial2/1/9/2:0] pim ipv6 sm
[RouterB-Serial2/1/9/2:0] quit
[RouterB] pim ipv6
[RouterB-pim6] bidir-pim enable
[RouterB-pim6] quit
# On Router C, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable
IPv6 BIDIR-PIM.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface Serial 2/1/9/1:0
Interface
—
—
—
Figure 118. (Details not shown.)
IPv6 address
5001::2/64
2001::2/64
4001::2/64
441