HP A8800 Configuration Manual page 224

[RouterB-msdp] originating-rp loopback 0
[RouterB-msdp] peer 2.2.2.2 connect-interface loopback 0
[RouterB-msdp] quit
# Configure an MSDP peer on Loopback 0 of Router D.
[RouterD] msdp
[RouterD-msdp] originating-rp loopback 0
[RouterD-msdp] peer 1.1.1.1 connect-interface loopback 0
[RouterD-msdp] quit
Verify the configuration
You can use the display msdp brief command to view the brief information of MSDP peering
relationships between the routers.
# Display brief MSDP peer information on Router B.
[RouterB] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured
1
Peer's Address
2.2.2.2
# Display brief MSDP peer information on Router D.
[RouterD] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured
1
Peer's Address
1.1.1.1
To view the PIM routing information on each router, use the display pim routing-table command.
When Source 1 10.1 10.5.100/24 sends multicast data to multicast group G 225.1.1.1, Host A joins
multicast group G. By comparing the PIM routing information displayed on Router B with that displayed
on Router D, you can see that Router B acts now as the RP for Source 1 and Host A.
# Display PIM routing information on Router B.
[RouterB] display pim routing-table
VPN-Instance: public net
Total 1 (*, G) entry; 1 (S, G) entry
(*, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:15:04
Upstream interface: Register
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet3/1/1
Up Listen
1 0
State Up/Down time
Up 00:10:17
Up Listen
1 0
State Up/Down time
Up 00:10:18
Connect Shutdown
0 0
AS SA Count
? 0
Connect Shutdown
0 0
AS SA Count
? 0
212
Down
0
Reset Count
0
Down
0
Reset Count
0