Step
5.
Enable default route
redistribution into the MBGP
routing table.
Configuring MBGP route summarization
To reduce the routing table size on medium and large MBGP networks, you need to configure route
summarization on peers. MBGP supports automatic and manual summarization modes.
•
Automatic summarization—Summarizes subnets redistributed from IGP. With the feature
configured, MBGP advertises only summary natural networks rather than subnets. The default
routes and routes injected with the network command are not summarized.
Manual summarization—Summarizes MBGP local routes. A manual summary route has a higher
•
priority than an automatic one.
To configure MBGP route summarization:
Step
1.
Enter system view.
2.
Enter BGP view.
3.
Enter IPv4 MBGP address family
view.
4.
Configure MBGP route
summarization.
Advertising a default route to an IPv4 MBGP peer or peer
group
Step
1.
Enter system view.
2.
Enter BGP view.
3.
Enter IPv4 MBGP address
family view.
Command
default-route imported
Command
system-view
bgp as-number
ipv4-family multicast
•
Enable automatic route summarization:
summary automatic
•
Configure manual route summarization:
aggregate ip-address { mask |
mask-length } [ as-set | attribute-policy
route-policy-name | detail-suppressed |
origin-policy route-policy-name |
suppress-policy route-policy-name ] *
Command
system-view
bgp as-number
ipv4-family multicast
223
Remarks
Not enabled by default.
Remarks
N/A
N/A
N/A
Use either
approach.
By default, no route
summarization is
configured.
If both are
configured, the
manual route
summarization takes
effect.
Remarks
N/A
N/A
N/A