Setting The Maximum Number Of Ipv6 Multicast Groups That An Interface Can Join - HP A8800 Configuration Manual

Setting the maximum number of IPv6 multicast groups that an
interface can join
Step
1. Enter system view.
2. Enter interface view.
3. Configure the maximum number of
IPv6 multicast groups that the
interface can join.
NOTE:
This configuration only limits the number of IPv6 multicast groups that the interface dynamically joins.
Adjusting MLD performance
For the configuration tasks in this section:
In MLD view, the configuration is effective globally. In interface view, the configuration is effective
•
on only the current interface.
If the same function or parameter is configured in both MLD view and interface view, the
•
configuration performed in interface view is given priority, regardless of the configuration
sequence.
Configuration prerequisites
Before adjusting MLD performance, complete the following tasks:
Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
•
domain can be interoperable at the network layer.
Configure basic functions of MLD.
•
Determine the startup query interval.
•
Command
system-view
interface interface-type
interface-number
mld group-limit limit
356
Remarks
N/A
N/A
The default value varies with
interface views and the
system operating modes.
In Layer 2 interface view, the
default value is 1024 in each
system operating mode.
In Layer 3 interface view, the
default value varies as
follows:
•
In SPE mode—8192.
•
In SPC mode—8192.
•
In hybrid mode—8192.
For more information about
the system operating modes,
see Fundamentals
Configuration Guide.