Configuration Task List - HP A8800 Configuration Manual
Ip multicast
Hide thumbs
Also See for A8800:
- Installation manual (121 pages) ,
- Command reference manual (153 pages) ,
- Fundamentals command reference (193 pages)
Table of Contents
Advertisement
Figure 91 IPv6 multicast data transmission through a tunnel
As shown in
B, Router A encapsulates the IPv6 multicast data in unicast IPv6 packets, and forwards them to Router B
across the GRE tunnel through unicast routers. Then, Router B strips off the unicast IPv6 header and
continues to forward the IPv6 multicast data down toward the receivers.
Configuration task list
Task
Enabling IPv6 multicast routing
Configuring IPv6 multicast
routing and forwarding
Enabling IPv6 multicast routing
Before configuring any Layer 3 IPv6 multicast functionality, you must enable IPv6 multicast routing.
To enable IPv6 multicast routing:
Step
1.
Enter system view.
2.
Enable IPv6 multicast routing.
Configuring IPv6 multicast routing and forwarding
Before configuring IPv6 multicast routing and forwarding, complete the following tasks:
Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
•
domain are interoperable at the network layer.
Figure
91, with a GRE tunnel established between the multicast routers Router A and Router
Configuring an IPv6 multicast routing policy
Configuring an IPv6 multicast forwarding range
Configuring the IPv6 multicast forwarding table size
Configuring RPF check failure processing
Command
system-view
multicast ipv6 routing-enable
335
Remarks
Required.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
Disabled by default.
Advertisement
Table of Contents
Troubleshooting
