HP A8800 Configuration Manual page 188

Figure 53 Network diagram
Receiver 1
Host A
Source 1
Table 12 shows the interface and IP address assignment, and network topology scheme.
Table 12 Interface and IP address assignment
Device
Router A
Router A
Router B
Router B
Router B
Router C
Router C
Router C
Router D
Router D
Router D
Source 1
Source 2
Receiver 1
Receiver 2
Configuration procedure
1. Configure the IP address and subnet mask for each interface as per
2. Configure OSPF on the routers in the BIDIR-PIM domain to ensure network-layer reachability
among them. (Details not shown.)
3. Enable IP multicast routing, PIM-SM, BIDIR-PIM, and IGMP;
Router B
GE3/1/1 S2/1/9/2:0
S2/1/9/1:0
S2/1/9/1:0
GE3/1/1
Router A
Interface
GigabitEthernet 3/1/1
Serial 2/1/9/1:0
GigabitEthernet 3/1/1
Serial 2/1/9/1:0
Serial 2/1/9/2:0
Serial 2/1/9/1:0
Serial 2/1/9/2:0
Loopback 0
GigabitEthernet 3/1/1
GigabitEthernet 3/1/2
Serial 2/1/9/1:0
—
—
—
—
Loop0
S2/1/9/1:0
S2/1/9/2:0
BIDIR-PIM
S2/1/9/1:0
Router D
IP address
192.168.1.1/24
10.110.1.1/24
192.168.2.1/24
10.110.1.2/24
10.110.2.1/24
10.110.2.2/24
10.110.3.1/24
1.1.1.1/32
192.168.3.1/24
192.168.4.1/24
10.110.3.2/24
192.168.1.100/24
192.168.4.100/24
192.168.2.100/24
192.168.3.100/24
176
Receiver 2
Router C
Host B
Source 2
GE3/1/2
Figure 53. (Details not shown.)