HP A8800 Configuration Manual page 223

Device
Router B
Configuration procedure
Assign an IP address and subnet mask to each interface as per
1.
2. Configure OSPF for interconnection between the routers in the PIM-SM domain. Ensure the
network-layer interoperation among the routers, and ensure the dynamic update of routing
information through a unicast routing protocol. (Details not shown.)
3. Enable IP multicast routing, and enable PIM-SM and IGMP:
# Enable IP multicast routing on Router B, enable PIM-SM on each interface, and enable IGMP on
the host-side interface GigabitEthernet3/1/1.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface GigabitEthernet3/1/1
[RouterB-GigabitEthernet3/1/1] igmp enable
[RouterB-GigabitEthernet3/1/1] pim sm
[RouterB-GigabitEthernet3/1/1] quit
[RouterB] interface serial 4/1/9/1:0
[RouterB-Serial4/1/9/1:0] pim sm
[RouterB-Serial4/1/9/1:0] quit
[RouterB] interface pos 5/1/1
[RouterB-Pos5/1/1] pim sm
[RouterB-Pos5/1/1] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] pim sm
[RouterB-LoopBack0] quit
[RouterB] interface loopback 10
[RouterB-LoopBack10] pim sm
[RouterB-LoopBack10] quit
[RouterB] interface loopback 20
[RouterB-LoopBack20] pim sm
[RouterB-LoopBack20] quit
# Enable IP multicast routing, and enable PIM-SM and IGMP on Router A, Router C, Router D, and
Router E in the same way. (Details not shown.)
4. Configure the position of C-BSR and C-RP:
# Configure Loopback 10 as a C-BSR and Loopback 20 as a C-RP on Router B.
[RouterB] pim
[RouterB-pim] c-bsr loopback 10
[RouterB-pim] c-rp loopback 20
[RouterB-pim] quit
# Configure the position of C-BSR and C-RP on Router D in the same way. (Details not shown.)
5. Configure MSDP peers:
# Configure an MSDP peer on Loopback 0 of Router B.
[RouterB] msdp
Interface IP address
Loop20 10.1.1.1/32
Device
Router E
211
Interface IP address
GE3/1/1 10.110.6.1/24
S4/1/9/1:0 10.110.4.2/24
Figure 61. (Details not shown.)