Reference Guide For Setting Parameters In Db1 - Siemens SIMATIC S5-100U System Manual

Integrated Blocks and Their Functions
9.1.7

Reference Guide for Setting Parameters in DB1

Parameter
Block ID: SL1:
SLN
SF
EF
KBE
KBS
PGN
p=1 to 3
Block ID:SDP:
WD
p=1 to 2550
Block ID: TFB:
OB13
p=0 to 655350 (State in 10-ms steps)
Block ID: CLP:
CF
DBxDWy,MWz,EWv
CLK
DBxDWy,MWz,EWv
STW
STP
SAV
OHE
SET
hh:mn:ss
TIS
hh:mn:ss
hhhhhh:mn:ss
OHS
wd =1 to 7 (weekday = Sun..Sat)
dd =01 to 31 (day)
mm =01 to 12 (month)
yy =0 to 99 (year)
hh =00 to 23 (hours)
mn =00 to 59 (minutes)
ss =00 to 59 (seconds)
hhhhhh =0 to 999999 (hours)
1 If an argument such as seconds, for example, is not to be entered, input XX. The clock continues to run
with the updated data. The TIS parameter block does not acknowledge this argument..
2
If you input AM or PM after the clock time, the clock runs in the 12-hour mode. If you omit this
argument, the clock runs in the 24-hour mode. You must use the same time mode in the SET and TIS
parameter blocks.
9-10
Argument
p Slave number
DBx DWy Location of Send Mailbox
DBxDWy Location of Receive Mailbox
MBy Location of Coordination Byte "Receive"
MBy Location of Coordination Byte "Send"
p Programmer bus number
x=2 to 255 y=0 to 255
Number of timers being processed( W atch- D og- T imer)
p
p Intervals (ms) at which OB13 is called up and is
processed
Inputting the correction factor ( C orrection F actor)
p
Location of the clock data ( CL oc K Data)
or AWv
Location of the status word ( ST atus W ord)
or AWv
J/Y/N Updating the clock during STOP ( ST o P)
J/Y/N Saving the clock time after the last change from RUN
to STOP or Power OFF ( SAV e)
J/Y/N Enabling the operating hours counter
( O peration H our counter E nable)
wd dd.mm.jj Setting the clock time and date
1 2
AM/PM
wd dd.mm. Setting the prompting time ( TI mer S et)
1 2
AM/PM
1
Setting the operating hours counter
( O peration H our counter S et)
x=2 to 255
Meaning
SINEC L1 (SL1)
System-Dependent-Parameter (SDP)
Timer-Funktions-Baustein (TFB)
ClockParameters (CP)
p=– 400 to 400
v=0 to 126
y=0 to 255
z=0 to 254
j/J=ja(yes)
y/Y=yes
n/N=no
S5-100U
EWA 4NEB 812 6120-02b