Brake Maintenance - Toro Workman 07390 Operator's Manual

Figure 76
1. Cap (coolant-reserve tank)
5. Disconnect the lower radiator hose and allow
the coolant to flow into a drain pan.
Note:
When the coolant stops flowing, connect
the lower radiator hose.
6. Slowly fill the radiator with a 50/50 mixture of
water and permanent ethylene-glycol antifreeze
7. Top off the radiator and install the cap
75).
8. Slowly fill the coolant-reserve tank until level
reaches the bottom of the filler neck
9. Install the cap on the coolant-reserve tank
(Figure 76).
10. Start the engine and operate it until it is warm.
11. Shut off the engine, check the coolant level, and
replenish the coolant, if required.

Brake Maintenance

Adjusting the Parking
Brake
1
Service Interval: After the first 10 hours
1. Remove the rubber grip from the parking-brake
G021229
g021229
(Figure
1. Grip
(Figure 76).
2. Loosen the set screw securing the knob to the
1. Knob
2. Set screw
3. Rotate the knob
4. Tighten the set screw when finished
58
Every 200 hours
lever (Figure 77).
Figure 77
parking-brake lever (Figure
Figure 78
(Figure
to 22 kg (45 to 50 lb) is required to actuate the
lever.
Note:
If you can no longer make a parking-brake
adjustment by adjusting the parking-brake
lever, loosen the handle to the middle of the
adjustment and adjust the cable at the rear, then
repeat step 3.
g033258
2. Parking-brake lever
78).
g033259
3. Parking-brake lever
78) until a force of 20
(Figure 78).