Operating On Rough Terrain - Toro Workman 07390 Operator's Manual

Operating on Rough Terrain

Reduce the ground speed of the machine and the
load carried in the machine when operating on rough
terrain, uneven ground, and near curbs, holes, and
other sudden changes in terrain. Loads may shift,
causing the machine to become unstable.
WARNING
Sudden changes in terrain may cause abrupt
steering wheel movement, possibly resulting
in hand and arm injuries.
• Reduce your speed when operating on
rough terrain and near curbs.
• Grip the steering wheel loosely around the
perimeter keeping thumbs up and out of
the way of the steering wheel spokes.
Loading and Dumping
•
Do not exceed the rated weight capacity of the
machine when operating it with a load in the
cargo box, when towing a trailer, or both; refer to
Specifications (page
•
Use caution when operating the machine on a
hillside or on rough terrain, particularly with a load
in the cargo box or when towing a trailer or both.
•
Be aware that the stability and control of the
machine are reduced when the load in the cargo
box is poorly distributed.
•
Carrying oversized loads in the cargo box changes
the stability of the machine.
•
The steering, braking, and stability of the machine
are affected when carrying a load where the weight
of the material cannot be bound to the machine,
such as the liquid in a large tank.
WARNING
The weight of the box may be heavy. Hands
or other body parts could be crushed.
– Keep your hands and other body parts
away when lowering the box.
– Do not dump materials on bystanders.
•
Do not dump a loaded cargo box while the machine
is sideways on a hill. The change in weight
distribution may cause the machine to overturn.
•
When operating with a heavy load in the cargo
box, reduce your speed and allow for sufficient
braking distance. Do not suddenly apply the
brakes. Use extra caution on slopes.
•
Be aware that heavy loads increase your stopping
distance and reduce your ability to turn quickly
without tipping over.
23).
•
The rear cargo space is intended for load carrying
purposes only, not for passengers.
•
Do not overload your machine. The name plate
(located under the middle of the dash) shows
the load limits for the machine. Do not overload
attachments or exceed the machine maximum
gross vehicle weight (GVW).
Hauling the Machine
•
Use care when loading or unloading the machine
into a trailer or a truck.
•
Use full-width ramps for loading the machine into
a trailer or a truck.
•
Tie the machine down securely.
Maintenance
WARNING
Hydraulic fluid escaping under pressure can
have sufficient force to penetrate skin and do
serious damage. If fluid is injected into the
skin, it must be surgically removed within a
few hours by a doctor familiar with this form
of injury; otherwise gangrene may result.
Keep your body and hands away from pinhole
leaks or nozzles that eject hydraulic fluid
under high pressure. Use paper or cardboard,
not your hands, to search for leaks.
•
Before servicing or making any adjustments to the
machine, park the machine on a level surface,
engage the parking brake, shut off the engine, and
remove the key to prevent accidental starting of
the machine.
•
Do not work under a raised bed without placing the
bed safety support on the fully-extended cylinder
rod.
•
Ensure that all hydraulic-line connectors are tight
and that all the hydraulic hoses and lines are in
good condition before applying pressure to the
system.
•
Before disconnecting or performing any work on
the hydraulic system, relieve all pressure in the
system by shutting off the engine, cycling the
dump valve from raise to lower, and/or lowering the
box and attachments. Place the remote hydraulics
lever in the float position. If the box must be in
raised position, secure it with the safety support.
•
To ensure that the entire machine is in good
condition, keep all the nuts, bolts, and screws
properly tightened.
7