Pre-Maintenance Procedures - Toro Workman 07390 Operator's Manual

Pre-Maintenance
Procedures
Many of the subjects covered in this maintenance
section require raising and lowering the bed. To
prevent serious injury or death, take the following
precautions.
WARNING
A raised bed full of material without the proper
safety support may lower unexpectedly.
Working under an unsupported raised bed
may cause injury to you or others.
• Before servicing or making adjustments to
the machine, shut off the engine, engage
the parking brake, and remove the key
from the key switch.
• Remove any load material from the bed
or other attachment and insert the safety
support on a fully extended cylinder rod
before working under a raised bed.
Using the Bed Support
Important:
Always install or remove the bed
support from the outside of the bed.
1. Raise the bed until the lift cylinders are fully
extended.
2. Remove the bed support from the storage
brackets on the back of the ROPS panel
38).
1. Bed support
3. Push the bed support onto the cylinder rod,
ensuring that the support end tabs rest on the
end of cylinder barrel, and on the cylinder rod
end (Figure
(Figure
1. Bed support
2. Cylinder barrel
4. Remove the bed support from the cylinder and
insert it into the brackets on the back of the
ROPS panel.
Important:
the bed-safety support on the cylinder.
40
Figure 38
39).
Figure 39
3. Bed
Do not try to lower the bed with
g026142
g009164