Brake Maintenance; Checking The Brake-Fluid Level - Toro 07384 Operator's Manual

Figure 56
1. Reserve tank-cap
2. Reserve tank
5. Disconnect the lower radiator hose and allow
the coolant to flow into a drain pan.
Note:
When the coolant stops flowing, connect
the lower radiator hose.
6. Slowly fill the radiator with a 50/50 mixture of
water and permanent ethylene-glycol antifreeze
7. Top off the radiator and install the cap
55).
8. Slowly fill the coolant-reserve tank until level
reaches the bottom of the filler neck
9. Install the reserve-tank cap
10. Start the engine and operate it until it is warm.
11. Shut off the engine, check the coolant level, and
replenish the coolant, if necessary.
g026143
(Figure
(Figure 56).
(Figure 56).
51

Brake Maintenance

Checking the Brake-Fluid
Level
Service Interval: Before each use or daily—Check
the brake-fluid level. Check the
brake-fluid level before you first start
the engine.
Every 1,000 hours/Every 2 years (whichever
comes first)—Change the brake fluid.
Brake-fluid type: DOT 3
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Raise the hood to access to the master brake
cylinder and reservoir
Figure 57
1. Brake-fluid reservoir
5. Ensure that the fluid level is up to the Full line on
the reservoir (Figure
(Figure 57).
58).
g009817