Maintaining The Transmission - Toro Workman 07390 Operator's Manual

Maintaining the
Transmission
Checking the Transmission-Fluid
Level
Service Interval: After the first 50 hours
Every 400 hours
Transmission Fluid Type: Dexron VI
1. Locate the fill plug at the at the lower-inboard
area at the back of the transmission
Figure 65
1. Fill port (transmission)
2. Align a drain pan below the fill plug.
3. Rotate the plug counterclockwise and remove
the plug from the fill port in the transmission
(Figure 65).
Note:
When the transmission fluid level is
correct, the fluid should be level with the bottom
of the threads in the fill port.
4. If the transmission-fluid level is low, add
transmission fluid of the specified type into the
transmission through the fill port until the fluid
level is flush with the bottom of the threads in
the port (Figure 65).
Note:
Use a funnel with a flexible hose when
filling the transmission.
5. Check the condition of the O-ring at the fill plug.
Note:
Replace the O-ring if it is warn or
damaged.
6. Install the fill plug into the transmission and
tighten it by hand
(Figure
2. Fill plug
(Figure 65).
Changing the Transmission Fluid
Transmission Fluid Type: Dexron VI
Transmission Fluid Capacity: 700 ml (23.7 oz)
1. Move the machine to a level surface.
2. Locate the fill plug at the back inboard area
of the transmission case and the locate the
drain plug at the front outboard side of the
transmission
65).
1. Fill plug
2. Transmission case (back
g025534
inboard location)
1. Forward
3. Remove the fill plug from the fill port by rotating
the plug counterclockwise and removing it from
the transmission
4. Align a drain pan below the drain plug
67).
53
(Figure 66 and Figure 67).
Figure 66
3. Forward
Figure 67
2. Drain plug
(Figure 66).
g025527
g025528
(Figure