Checking The Fluid Levels - Toro Workman 07390 Operator's Manual

Figure 19
1. Latch handle
2. Latch gate

Checking the Fluid Levels

Preparing to Check the Fluid
Levels
1. Move the machine to a level surface.
2. Shift the transmission to the P
off the engine, engage the parking brake, and
remove the key from the key switch.
3. Allow the machine to cool before you check the
fluid levels of the machine.
4. Check the following:
•
Checking the Engine-Oil Level (page 25)
•
Checking the Hydraulic-Fluid Level (page
26)
•
Checking the Engine-Coolant Level (page
27)
•
Checking the Brake-Fluid Level (page 28)
g026141
3. Latch pin
position, shut
ARK
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check
the engine-oil level. (Check the oil
level before and after the engine is
first started and daily thereafter.)
Oil Type: 10W-30 API SJ or higher.
Refer to the table in
according to ambient-air temperature.
Note:
The engine is shipped with approximately 2.0
L (2.1 US qt) of oil in the crankcase (including the oil
filter).
Note:
The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If the engine has already ran, shut it off and wait
for at least 10 minutes before checking the oil level.
1. Remove the dipstick and wipe it with a clean rag
(Figure 21).
1. Dipstick tube
2. Filler neck
2. Insert the dipstick into the tube and make sure
that it is seated fully.
25
Figure 20 for oil viscosity
Figure 20
Figure 21
3. Filler cap
4. Dipstick
G016095
g016095
g025526