Transporting The Machine - Toro Workman 07390 Operator's Manual

4. Rotate the key switch clockwise to the S
position.
Note:
Do not press the brake pedal.
Note:
If the engine cranks or starts, there is a
malfunction in the safety-interlock system that
you must repair before operating the machine.
Verifying the High-Flow-Hydraulic
Safety-Interlock Switch
Note:
This procedure is for a non-TC model with the
High-Flow-Hydraulic Kit (option) or a TC model
1. Sit on the operator's seat and engage the
parking brake.
2. Move the shift lever to the N
and ensure that the hydraulic-lift lever is in the
center position.
3. Set the high-flow-hydraulic switch to the O
position.
4. Press brake pedal.
5. Rotate the key switch clockwise to the S
position.
Note:
If the engine cranks or starts, there is a
malfunction in the safety-interlock system that
you must repair before operating the machine.

Transporting the Machine

Use a trailer with full-width ramps to move the
machine a long distance. Make sure that the machine
is securely bound to the trailer. Refer to
Figure 36 for the location of the tie-down points.
Note:
Load the machine on the trailer with the front
of the machine facing forward. If that is not possible,
secure the machine hood to the frame with a strap,
or remove the hood and transport and secure it
separately or the hood may blow off during transport.
Figure 35
1. Eye hole in the frame (each side)
TART
position
EUTRAL
N
TART
Figure 35 and
g009820
35
Figure 36
1. Axle
Towing the Machine
In case of an emergency, the machine can be
towed for a short distance. However, Toro does not
recommend this as a standard procedure.
WARNING
Towing at excessive speeds could cause the
machine to lose steering control. Never tow
the machine at faster than 8 kph (5 mph).
Towing the machine is a 2-person job. Affix a tow
line to holes in the front frame member. Move the
shift lever to the N
EUTRAL
the parking brake. If the machine must be moved a
considerable distance, transport it on a truck or trailer.
Note:
The power steering does not function,
making it difficult to steer.
Towing a Trailer with the
Machine
The machine is capable of pulling trailers and
attachments of greater weight than the machine itself.
Several types of tow hitches are available for the
machine, depending on your application. Contact your
Authorized Toro Distributor for details.
When equipped with a tow hitch bolted onto the
rear axle tube, your machine can tow trailers or
attachments with a gross trailer weight (GTW) up to
1587 kg (3,500 lb). Always load a trailer with 60% of
the cargo weight in the front of the trailer. This places
approximately 10% (272 kg (600 lb) maximum) of
the gross trailer weight (GTW) on the tow hitch of the
machine.
When hauling cargo or towing a trailer (attachment),
do not overload your machine or trailer. Overloading
2. Hitch plate
position and disengage
g009821