Brake Maintenance; Checking The Brake-Fluid Level; Adjusting The Parking Brake - Toro Workman HDX-D Operator's Manual

Brake Maintenance

Checking the Brake-Fluid
Level
Service Interval: Before each use or daily—Check
the brake-fluid level. Check the
brake-fluid level before you first start
the engine.
Every 1,000 hours/Every 2 years (whichever
comes first)—Change the brake fluid.
Brake-fluid type: DOT 3
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Raise the hood to access to the master brake
cylinder and reservoir
Figure 54
1. Brake-fluid reservoir
5. Ensure that the fluid level is up to the Full line on
the reservoir (Figure
(Figure 54).
55).
1. Brake-fluid reservoir
6. If the fluid level is low, clean the area around
the cap, remove the reservoir cap, and fill the
reservoir to the proper level with the specified
brake fluid
Note:
Do not overfill the reservoir with brake
fluid.
Adjusting the Parking
Brake
Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking-brake
lever (Figure
g009817
1. Grip
2. Loosen the set screw securing the knob to the
parking-brake lever
53
Figure 55
(Figure 55).
56).
Figure 56
2. Parking-brake lever
(Figure 57).
g002379
g033487