Changing The Engine Oil And Filter - Toro Workman 07390 Operator's Manual

6. Clean the dirt-ejection port located in the
air-cleaner cover, the dust-valve cavity, and
replace the dust valve
7. Inspect the new air filter for shipping damage,
checking the sealing end of the filter and the
body.
Important:
Do not use a damaged element.
8. Insert the new air filter by applying light pressure
to the outer rim of the filter to seat it in the
air-filter housing
9. Align the air-filter cover with the dust valve at the
6 o'clock position when viewed from the left end
of the cover (Figure
10. Secure the latch of the air-filter cover
50).
Note:
Reset the indicator if it shows red (if
equipped).
Changing the Engine Oil
and Filter
Service Interval: After the first 50 hours
Every 200 hours
Engine-oil capacity: 2.0 L (2.1 US qt) of oil in the
crankcase (including the oil filter)
Oil Type: 10W-30 API SJ or higher
Choose a viscosity according to the table in
1. Raise the bed (if equipped) and place the bed
safety support on the extended lift cylinder to
hold up the bed.
2. Align a large drain pan under the oil-drain plug
for the engine (Figure
(Figure 50).
(Figure 50).
50).
(Figure
Figure
Figure 51
52).
1. Engine-oil-drain plug
2. Forward
3. Remove the drain plug and let oil flow into a
drain pan
Note:
When the oil stops draining, install the
drain plug.
4. Remove the oil filter from the filter adapter
(Figure 53).
51.
1. Forward
g001902
2. Oil filter
5. Wipe clean the sealing base of the of the filter
adapter (Figure
6. Apply a light coat of clean oil to the seal of the
new filter.
7. Install the filter until the gasket contacts the
sealing base of the filter adapter, then tighten
the filter clockwise and additional 1/2 to 2/3 of
a turn (Figure
Note:
Do not overtighten the engine oil filter.
46
Figure 52
(Figure 52).
Figure 53
3. Filter adapter
53).
53).
g025525
g025524