Controls System Maintenance - Toro Workman 07390 Operator's Manual

Controls System
Maintenance
Converting the
Speedometer
You can convert the speedometer from mph to kpm
or kph to mph.
1. Position the machine on a level surface, shut
off the engine, engage the parking brake, and
remove the key from the key switch.
2. Remove the hood.
3. Locate the 2 loose wires next to the meter
(Figure 81).
Figure 81
1. meter (forward face)
2. Plug
4. Remove the connector plug from the harness
wire and connect the wires together
Note:
The meter switches from mph to
kph. Retain the plug in order to convert the
speedometer to mph.
5. Install the hood; refer to
(page 43).
g024896
3. Speedometer wires
(Figure 81).
Installing the Hood
Hydraulic System
Maintenance
Replacing the Hydraulic
Filter
Service Interval: After the first 10 hours
Every 800 hours
Important:
Use of any other filter may void the
warranty on some components.
1. Position the machine on a level surface, shut
off the engine, engage the parking brake, and
remove the key from the key switch.
2. Clean the area around filter-mounting area
(Figure 82).
1. Filter adapter
3. Place a drain pan under the filter
4. Remove the filter by rotating it counterclockwise
(Figure 82).
5. Clean the filter-seating surface of the filter
adapter (Figure
6. Lubricate the gasket on the new filter with the
specified Mobil M15 hydraulic fluid.
7. Thread the filter onto the filter adapter until the
gasket of the filter contacts the seating surface
of the adapter
filter an additional 1/2 turn
8. Start the engine and let it run for about 2 minutes
to purge air from the system.
9. Shut off the engine and check the hydraulic-fluid
level in the reservoir and the filter area for leaks.
60
Figure 82
2. Hydraulic filter
(Figure
82).
(Figure 82), and then tighten the
(Figure 82).
g025557
82).