Breaking In A New Machine - Toro Workman 07390 Operator's Manual

Figure 34
1. Lock position
(differential-lock switch)

Breaking in a New Machine

•
Ensure that the brakes are burnished; refer to
Burnishing the Brakes (page
•
Check the fluid and engine-oil levels regularly
and be alert for indications of overheating in any
component of the machine.
•
After starting a cold engine, let it warm up for about
15 seconds before shifting into gear.
Note:
Allow more time to warm up the engine
when operating in cold temperatures.
•
Avoid racing the engine.
•
Vary machine speeds during operation. Avoid
excessive idling. Avoid fast starts and quick stops.
•
Refer to Maintenance (page 38)
low-hour checks.
g025547
2. Unlock position
(differential-lock switch)
6
17).
for any special,
Checking the
Safety-Interlock System
Service Interval: Before each use or daily
The purpose of the safety-interlock system is to
prevent the engine from cranking or starting unless
the brake pedal is pressed and the hydraulic-lift lever
is in the N position.
EUTRAL
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly causing personal injury.
• Do not tamper with the safety-interlock
switches.
• Check the operation of the safety-interlock
switches daily and replace any damaged
switches before operating the machine.
Note:
Refer to the Attachment Operator's Manual
for procedures on checking the attachment-interlock
system.
Verifying the Hydraulic-Lift Lever
Safety-Interlock Switch
1. Sit on the operator's seat and engage the
parking brake.
2. Move the shift lever to the N
and ensure that the hydraulic-lift lever is in the
center position.
3. If you have a non-TC model with the
High-Flow-Hydraulic Kit (option) or TC model,
set the high-flow-hydraulic switch to the O
position.
4. Press brake pedal.
5. Move the hydraulic-lift lever forward and rotate
the key switch clockwise to the S
Note:
If the engine cranks or starts, there is a
malfunction in the safety-interlock system that
you must repair before operating the machine.
Verifying the Brake Pedal
Safety-Interlock Switch
1. Sit on the operator's seat and engage the
parking brake.
2. Move the shift lever to the N
and ensure that the hydraulic-lift lever is in the
center position.
3. If you have a non-TC model with the High-Flow
Hydraulic Kit (option) or TC model, set the
high-flow-hydraulic switch to the O
34
position
EUTRAL
FF
position.
TART
position
EUTRAL
position.
FF