Lubrication - Toro Workman 07390 Operator's Manual

Lubrication

Greasing the Bearings and
the Bushings
Service Interval: Every 100 hours (lubricate
more frequently in heavy duty
applications).
Lubrication type: No. 2 lithium grease
Important:
When greasing the drive shaft
universal shaft bearing crosses, pump grease
until it comes out of all 4 cups at each cross.
1. Wipe each grease fitting clean so that foreign
matter cannot be forced into the bearing or
bushing.
2. Connect the grease gun to the grease fitting.
3. Pump grease into each bearing or bushing.
4. Wipe off any excess grease.
The grease fitting locations and quantities are as
follows:
•
Ball joints (4); refer to
•
Pivot mounts (2); refer to
•
Steering cylinder (2); refer to
•
Tie rods (2); refer to
Figure 46
Figure 46
Figure 46
Figure 46
Figure 46
Spring tower (2); refer to
•
Brake (1); refer to
•
Throttle (1); refer to
g010360
44
Figure 47
Figure 47
Figure 48
Figure 48
Figure 48
g010571
g025519