Konica Minolta bizhub 164 Service Manual page 61

4. PERIODICAL MAINTENANCE PROCEDURE
(c)
(b)
[3]
[1]
9. To reinstall, reverse the order of removal.
24
[1]
[2]
(a)
A0XXF2E515DA
A0XXF2E010DA
Field Service Ver. 2.0 Jun. 2010
7. Remove three screws [1], and
remove the developer scattering pre-
vention plate [2].
NOTE
• When securing the developer scat-
tering prevention plate, tighten
screws in the order of one on one
edge (a), one at the center (b), and
one on the other edge (c).
• When attaching the developer scat-
tering prevention plate, make sure
that the tabs of the developer scat-
tering prevention plate are inserted
into the slots [3].
8. Using a brush, whisk dust and dirt off
the surface of the developer scatter-
ing prevention plate [1].