Vfo Scan; D Memory Scan; Memory Bank Scan; Tone Scan - Icom ID-31A PLUS Advanced Manual

8
SCANNING
Scan type
Scanning is a versatile function that can automatically
search for signals A scan makes it easier to locate
stations to contact or listen to, or to skip unwanted
channels or frequencies
D VFO scan
ALL (Full scan)
Repeatedly scans the entire band
ID-31A/E PLUS
RX frequency
lower end
P SKIP
PROG 0 ~ 24 (Program scan)
Scans the Program Scan Edge channel
(00A/00B ~ 24A/24B) range (p 8-5)
Lower
edge
(XXA)
Jump
L At least one pair of Program Scan channel must
be entered to start a Program scan
P-LINK 0–9 (Program Link scan)
Sequentially scans the Program Scan Edge
channel ranges The links are set on the MENU
screen (MENU > Scan > Program Link)
See page 8-6 for more details
0 ：
Program Link
Edit Name
1 ：
9 ：
Program Link number (0 to 9)
ID-31A/E PLUS
RX frequency
upper end
Scan
P SKIP
Jump
Upper
edge
(XXB)
Scan range
Scan
Jump
Program Scan
Program Scan
lower edge
upper edge
(XXA)
(XXB)
00 ： 430.000−450.000
Delete
Blank
A pair of
Program Scan Edge channels

D Memory scan

ALL (Memory Full scan)
Scans all Memory channels
MODE (Mode Memory scan)
Scans Memory channels that are entered with the
same receiving mode as the currently selected
mode
D Memory Bank scan
ALL (Full Bank scan)
Scans all Banks
BANK-LINK (Bank Link scan)
Sequentially scans the Banks that are set to link on
the MENU screen (p 11-5)
(MENU > Scan > Bank Link)
BANK-A–Z (Bank scan)
Scans the Memory channels in the selected Bank
D Duplex (DUP) scan
The Duplex scan searches for signals in both
TX and RX frequencies that are used in duplex
operation
(p 10-4)
See pages 8-4, 8-9, or 8-10 for its operation
L "DUP–" or "DUP+" is displayed in the Duplex
mode
L A Duplex scan does not start when the
frequency offset is set to "0000 MHz"
D Tone scan
The Tone scan searches for signals in tone
frequencies or DTCS codes that are used by
stations using the Tone Squelch function
See pages 8-4, 8-9, or 8-10 for its operation
L A Tone scan is usable in any VFO, Memory, or
Call channel mode
L During a scan, rotate [DIAL] to change the scan
direction
See "Tone squelch operation" or "DTCS code
squelch operation" for details (pp 12-9, 12-10)
8-2