Voice Tx Items - Icom ID-31A PLUS Advanced Manual

11
MENU SCREEN

Voice TX items

NOTE: The default settings shown below are for the USA transceiver version� The default settings may differ,
depending on your transceiver version� To return to your transceiver version's default settings, see page 11-3�
Record
MENU > Voice TX > Record
Up to 1 minute of audio can be recorded onto a
microSD card for voice transmission� (p� 12-3)
The transceiver can save only 1 voice audio�
L BE SURE to insert a microSD card�
L While recording a QSO, you cannot use this function�
Repeat Time
MENU > Voice TX > TX Set > Repeat Time
Set the Repeat Time to between 1 and 15 seconds (in
1 second steps)�
The transceiver repeatedly transmits the recorded
voice audio for this set interval�
NOTE: The recorded voice audio is repeatedly
transmitted for up to 10 minutes� If 10 minutes
passes while transmitting, the transceiver
continues to transmit until the complete voice audio
transmission is finished.
TX Monitor
MENU > Voice TX > TX Set > TX Monitor
Turn the TX Monitor function ON or OFF�
• OFF: The TX voice audio is not heard from the
speaker�
• ON: The TX voice audio is heard from the speaker.
<<Single TX>>
MENU > Voice TX > <<Single TX>>
The transceiver transmits the recorded voice audio
only once�
L You can also select "Single TX" in the Quick Menu
<<Repeat TX>>
(Default: 5sec)
MENU > Voice TX > <<Repeat TX>>
The transceiver repeatedly transmits the recorded
voice audio for up to 10 minutes, according to the
Repeat Time setting�
L
• You can also select "Single TX" in the Quick Menu window�
• If 10 minutes passes while transmitting, the transceiver
• Any of the following action cancels the transmission�
(Default: ON)
11-8
window�
(Quick Menu > Voice TX > Single TX)
Information
(Quick Menu > Voice TX > Repeat TX)
continues to transmit until the complete voice audio
transmission is finished.
- Pushing [PTT]
- Turning OFF the transceiver, then turning it ON again�
- Pushing any key (except for [VOL] and [ ])