Icom ID-31A PLUS Advanced Manual page 128

8
SCANNING
Memory scan
NOTE: You must enter 2 or more Memory channels
that are not set as Skip channels to start a Memory
scan
1 Push [M/CALL] to enter the Memory mode
2 Hold down [SCAN] for 1 second
• Opens the Scan Type Select window
3 Select a scan type
▼
• The scan starts
• The decimal point and
L When receiving a signal, the S-meter displays the
received signal strength
4 Hold down [SCAN] for 1 second
• Cancels the scan
L Pushing [CLR] also cancels the scan
[Up]
[ENT]
[Down]
blink
D Scan type
• ALL: Full scan
• MODE: Mode scan
• DUP: Duplex scan
(Displayed only when duplex is set)
• TONE: Tone scan
(For the Tone squelch scanning)
L When 2 or more Memory channels that are not set
as Skip channels are entered, the Memory scan is
usable
L The channel that is set as a Skip channel (PSKIP
or SKIP) are skipped during a scan (p 8-11)
TIP:
• During a scan, rotate [DIAL] to change the
scanning direction
• During a scan, hold down [
function ON or OFF
• The scan continuously runs, even if you push
[MENU] or [QUICK] during a scan
• You can select a scan type by rotating [DIAL]
while holding down [SCAN] Release [SCAN] to
start the scan
8-9
] to turn the Lock