D The Voice Tx Settings - Icom ID-31A PLUS Advanced Manual

12
OTHER FUNCTIONS
Voice TX function
D Transmitting the recorded voice audio
NOTE: BE SURE to insert a microSD card into the
transceiver�
MENU > Voice TX > <<TX>>
1� Push [MENU]�
2� Select "Voice TX�"
3� Select an option�
• <<Single TX>>: The recorded voice audio is
transmitted only once�
• <<Repeat TX>>: The recorded voice audio is
repeatedly transmitted�
▼
Information
L
• While transmitting, the SD card icon blinks�
• When you select <<Repeat TX>>, the transceiver
repeatedly transmits the recorded voice audio for up to
10 minutes at the interval set in Repeat Time�
(MENU > Voice TX > TX Set > Repeat Time)
• To cancel a recorded voice transmission, push [PTT]�
• After the second transmission, the transmission
continues pausing, if receiving a signal, even if Busy
Lockout is set to ON�
(MENU > Function > Busy Lockout)
However, if the squelch is manually opened in the
FM mode, the voice audio is repeatedly transmitted,
according to the Repeat Time setting�
TIP: To send the recorded voice audio in the Quick
Menu window, push [QUICK], then select "Voice
TX�"
[Up]
[ENT]
[Down]
While transmitting
Transmission is
paused

D The Voice TX settings

You can change the Voice TX settings on the MENU
screen� (p� 11-8)
Setting the Repeat Time
Set the repeat interval for the voice repeat
transmission. (Default: 5 sec)
MENU > Voice TX > TX Set > Repeat Time
Using the TX Monitor function
The TX voice audio is output from the speaker�
(Default: ON)
MENU > Voice TX > TX Set > TX Monitor
12-4