Icom ID-31A PLUS Advanced Manual page 39

4
D-STAR OPERATION
Connecting to a reflector
D Linking to a reflector
If your repeater is not currently linked to a Reflector, or
if you want to change it to another Reflector, follow the
steps below. Before linking to another Reflector, BE
SURE to unlink the current Reflector. (p. 4-14)
Direct inputting a Reflector
Example: Directly enter "REF030CL"
1 Push [RX→CS] to select "TO," then push [ENT].
2 Select "Reflector"
3 Select "Link to Reflector."
4 Select "Direct Input"
5 Rotate [DIAL] to select the reflector number.
6 Push [CS] to move the cursor to the right box.
7 Rotate [DIAL] to select the module letter
8 Push [ENT]
• Returns to the DR screen, and "Link to Reflector" and
"REF030CL" are displayed in "TO"
9 Hold down [PTT] to link to the Reflector
[Up]
[ENT]
[Down]
Using TX History
TX History saves up to 5 reflectors that your Access
repeater linked to before
Example: Select the "REF030CL" in TX History
1 Push [RX→CS] to select "TO," then push [ENT].
• Displays the TO SELECT screen
2 Select "Reflector"
• Displays the REFLECTOR screen
3 Select "Link to Reflector."
• Displays the LINK TO REFLECTOR screen
4 Select the reflector that you want to link to.
• Returns to the DR screen, and "Link to Reflector" and
"REF030CL" are displayed in "TO"
5 Hold down [PTT] to link to the reflector
4-15