ABB ETL600 Instruction Manual page 309

ETL600 System Settings
No.
A.1 General
A.2 Create a configuration file using
HMI600
A.3 Racks and assemblies
A.3.1 Number of P7LA racks
Configuration file shows the correct
number of P7LA racks.
A.3.2 Assemblies in upper rack P7LA, if
present
Configuration file shows the correct
type of power supply B5LA or B5LC
in upper rack P7LA.
All assemblies in upper rack P7LA
are mounted at the correct positions
A.3.3 Assemblies in lower rack P7LA
Configuration file shows the correct
type of power supply B5LA or B5LC
in lower rack P7LA.
All assemblies in lower rack P7LA
are mounted at the correct positions
A.3.4 Assemblies in rack P7LC
Configuration file shows the correct
number and type of assemblies in
rack P7LC.
All assemblies in rack P7LC are
mounted at the correct positions
A.3.5 Check presence of spare plates in
rack P7LC.
Front of rack is completely covered
A.4 Settings for basic equipment
ETL640/80
A.4.1 Power amplifier P1LA
Wire bridges set according to
configuration file
A.4.2 Settings for B5LC, if present
Wire bridges and fuses correct for
specified supply voltage
*
'Upper' und 'Lower' stands for upper rack / lower rack and applies to 80 W equipment ETL680 only.
© ABB Switzerland Ltd
Revision:
_
Action
Config file
Config file
Upper* P7LA Assemblies
Config file
Lower P7LA Assemblies
Config file
Language: Page:
EN A1/A4
Item to be
programmed or
Rack or
fitted
module
HMI600
P7LC Assemblies
P7LC Spare plates
P1LA BB, DD, EE, FF
B5LC Wire bridges and
fuses
HE
Selected
alternative or
Remarks
setting
[ ]
Refer to
[ ]
hardware
[ ] Refer to
hardware
[ ] Refer to config
file
[ ] Refer to
hardware
[ ] Refer to config
file
Refer to
[ ]
hardware
[ ] Refer to config
file
[ ]
*
Upper
Lower
[ ] [ ]
Upper* Lower
[ ] [ ] Refer to
1KHL015788
Form 1KHW001493-EN
Rev. A