Assembly And Installation; Safety Instructions - ABB ETL600 Instruction Manual

ETL600
6.

ASSEMBLY AND INSTALLATION

The installation of the equipment can only be successfully
accomplished, if it is properly planned beforehand. Planning should not
only take the present situation into account; future system expansion
must also be included.
6.1.

Safety instructions

Personnel qualification
DANGER
Transportation
Caution
Caution
Mechanical Installation
DANGER
DANGER
Electrical Installation
DANGER
DANGER
Assembly and Installation
1KHW001489-EN
An authorized and properly trained personnel only is
admitted to carry out programming, commissioning,
maintenance, troubleshooting and work of the
equipment.
The following assemblies must be removed from the
cabinet and packed separately during transportation.
Power supply unit 115/230VAC B5LC
The plug-in units must be carefully but firmly
screwed into the racks to prevent them from falling
out. Separately packed modules and other loose
parts must be properly secured and suitably packed
to avoid damage.
The equipment must be mounted in a cabinet.
Cabinets, which are not secured to the floor, tip
forwards when the hinged frame is opened. Do not
open the hinged frame without precautions.
This is a Class Ι equipment as specified in
IEC 60950. The equipment and the cabinet must be
earthed.
The equipment must be supplied over the 'circuit
breaker for the power supply', type B9AS.
The circuit breaker for the power supply (B9AS) of
the equipment must be switched OFF.
The circuit breakers for optional equipment in the
cabinet must be switched OFF.
ABB Switzerland Ltd
November 2005 6-1