Interfaces - ABB ETL600 Instruction Manual

ETL600
6.6.3.

Interfaces

Connections to the various interfaces are made with cables equipped
with connectors or connector blocks that are normally mounted in the
back of the cabinet. The following table lists the interfaces and the
corresponding cables. The table also lists the recommended wire sizes
for the connector blocks.
Inter- External Type of connector or
face cable connector block
P4LT V9OW Sub-D 15 pole female
(V.11)
V9OU Sub-D 9 pole female
(RS-232
/ V.24)
V9OV Sub-D 9 pole female
(RS-485
/ IRIG-B)
V9OT Screw type terminals
(Phoenix)
R7AP LSA Plus Quick
Connect (Krone)
R1BC V9MR Screw type terminals
(Phoenix)
O4LE V9OD LSA Plus Quick
*) **), Connect (Krone)
V9OS
***)
G4AI V9OF Screw type terminals
**) (Phoenix)
Table 6-1
*) Another option of these cables is available in 20 meter length, which are
without LSA Plus Quick Connector. They can be used for terminating on
main distribution frame.
**) The shields of these cables must be earthed at both cable ends using the
shield clamps supplied with the cables.
Assembly and Installation
1KHW001489-EN
Recommended
wire size
2
1.5 mm
Solid 0.5 mm,
0.2 mm PVC
insulation
2
1.5 mm
Solid 0.4 mm,
0.2 mm PVC
insulation
2
1.5 mm
List of cables with wire sizes for connector blocks
November 2005
ABB Switzerland Ltd
Connector blocks:
Wire size range
Solid: 0.2 to 4.0 mm
Stranded: 0.2 to 2.5 mm
Solid, one wire:
0.4 to 0.8 mm
Solid, two wires:
0.4 to 0.65 mm,
both wires must have the
same diameter
Solid: 0.2 to 4.0 mm
Stranded: 0.2 to 2.5 mm
Solid, one wire:
0.4 to 0.8 mm
Solid, two wires:
0.4 to 0.65 mm,
both wires must have the
same diameter
Solid: 0.2 to 4.0 mm
Stranded: 0.2 to 2.5 mm
2
2
2
2
2
2
6-15