Furuno FEA-2107-BB Installation Manual page 32

2.3.2 Serial data channels in general
An example of serial channel (here channel 1)
RX1+ Input terminals for electrical standards IEC 61162-1, RS-232 and RS-422.
"RX+" and "RX-" may be defined as "RX-A" and "RX-B" in IEC 61162-1.
RX1-
TX1+ Output terminals for electrical standards IEC 61162-1 and RS-422.
"TX+" and "TX-" may be defined as "TX-A" and "TX-B" in IEC 61162-1.
TX1-
TX1 Output terminals for electrical standard RS-232C
GND Ground terminal for RS-232C
2.3.3 Standard serial data channel assignment
First LAN adapter
Channel Type bit/s
1 rx/tx 4800
2 rx 4800
3 rx/tx 4800
4 rx/tx 4800
5 rx/tx 38400
6 rx 4800
7 rx 38400* Gyro1
8 rx 4800
Relay1 Relay NO
Relay2 Relay NC
Relay3 Relay NC
Second LAN adapter
Channel Type bit/s
9 rx/tx 4800
10 rx 4800
11 rx/tx 4800
12 rx/tx 4800
13 rx/tx 38400
14 rx 4800
15 rx 38400* Wind Sensor
16 rx 4800
Relay4 Relay NC
Relay5 Relay NC
Relay6 Relay NC
Note: For Relay 2 to 6: Polarities are depending on Relay outputs settings (Normal open or
Normal Close) of "Alarm Inputs+Outputs/AMWSS". (Not available for program version
05.xx)
2-12
Default use
ARPA2
Pos1
Track pilot
ARPA1
AIS
Pos2
Log/Dual-axis log
Operator fitness
Any ECDIS alarm
Backup navigator
*Program version 05.xx: 4800
Default use
Route Backup
Engine Control
AMWSS
Navtex (Not available for program version 05.xx)
B-Adapter
Echo Sounder
Water temp
Waypoint approach
Outside channel limit
Depth below limit
*Program version 05.xx: 4800
2. WIRING