Furuno FEA-2107-BB Installation Manual page 104

3. ADJUSTMENTS
Speed pilot
Settings when speedpilot is not
connected.
Settings when speedpilot is
connected.
Alarm Inputs External
This function is not available for version
05.xx. You can define which sensors report
alarms to ECDIS.
-Check "Conn" for sensor reporting to
ECDIS.
-Check "Bi-dir" option, if acknowledge
message will be sent to alarm transmitting
sensor
-Check "Retry ack" option, if acknowledge
message to alarm transmitting sensor fails
to respond (retry three times)
In this example Position equipment 1 connected to channel 2 of LAN Adapter can report
alarm in Position equipment 1.
AIS in channel 5 of LAN Adapter reports alarm in AIS and they can be also acknowledged in
ECDIS or Central Alarm System.
Central Alarm Output
You can define channel for Central Alarm System to
where report sensor alarms.
-"Bi-directional" as YES, in case that if alarms can be
acknowledged from Central Alarm System.
-"Propagate RX alarms" used to define if alarm from
alarms transmitting sensor are sent further to Central
Alarm System.
3-62
Edit parameters - Alarm Inputs/External
Ch Conn Bi-dir Retry ack Alarm source name Ch Conn Bi-dir Retry ack Alarm source name
EXT1
1
POS1
3
RUDR2
4
EXT4
5
AIS
6
POS2
7
GYRO1
8
LOG
OK Cancel
Edit parameters - Central Alarm Output
Connected:
Adapter Chl:
Bi-directional:
Propagate RX alarms:
Device Type:
OK
EXT9
9
EXT10
10
BADAP
11
AMWSS
12
ROUTE
13
ECHO
14
WIND
15
EXT16
16
YES
13
YES
YES
IEC 61162-1 (4800 bit/s)
Cancel
x
x