Comtech EF Data CDM-425 Installation And Operation Manual page 514

10.3.3.3.3.3.1.1 ODU: FSK-control
Tx:Off
Use the ◄ ►arrow keys to select Tx, Freq, Att, or AGC, and then use the ▲▼ arrow keys to
change that setting. Press ENTER when done.
10.3.3.3.3.3.1.2 ODU: FSK-control
Rx: Freq=11950 MHz
The Rx Band information is not shown for the KST-2000A.
Use the ◄ ►arrow keys to select Freq, Att, Ref, or Band (KST-2000B only), and then use the
▲▼ arrow keys to change that setting. Press ENTER when done.
10.3.3.3.3.3.1.3 ODU: FSK-control
HPA:Off
LNA:OFF
Use the ◄ ►arrow keys to select HPA, (HPA) Fault-Logic-Summary, LNA, (LNA) Fault-Logic-
Summary, or Cal, and then use the ▲▼ arrow keys to change that setting:
Selection
HPA
Fault-Logic
LNA
Fault-Logic
Cal
Press ENTER when done.
ODU (Transceiver, BUC, LNB) Operation
 
KST Configuration
Freq=13955 MHz
 
KST Configuration
Band=B
 
KST Configuration
Fault-Logic=Summary
Fault-Logic=Summary
(HPA power enable) Select Off or On.
This controls whether or not a HPA fault is indicated on the Fault status, and activates the
Summary Fault Relay. Select Summary or No-Summary.
(LNA power enable) Select Off or On.
This controls whether or not a LNA fault is indicated on the Fault status, and l activates
the Summary Fault Relay. Select Summary or No-Summary.
To calibrate, select YES and press ENTER. Calibration allows the system to determine
nominal LNB or LNB power consumption, performed at initial installation only. (Default is
NO.)
CDM-425 Advanced Satellite Modem

Tx
Att=23 dB
AGC=Off ()

Rx
Att=20 dB Ref=087

Miscellaneous
Cal:No
Setting
10–24
Revision 0
()
MN-CDM-425