Table of Contents
Advertisement
Open the scrollable Utilities page from the Modem submenu. This page contains the following
options:
Hot Key Dialog Window
A
Unit Test Mode
B
Statistics Sample Interval
C
Request to Send
D
Circuit ID
E
Carrier ID State
F
Carrier ID Latitude Degrees
G
Carrier ID Latitude Minutes
H
Carrier ID Latitude Direction
Carrier ID Longitude
I
Degrees
J
Carrier ID Longitude Minutes
Carrier ID Longitude
K
Direction
L
Carrier ID Phone Number
M
Carrier ID Message
N
RTC Time
O
RTC Date
P
Tx Clock Source
Q
Rx Clock Source
R
Rx Buffer Size
S
Modem Reference Clock
T
G703 Clock Extend Mode
U
G703 Clock Extend Intf
V
Warm Up Delay
W
Warm Up Countdown
X
BERT Restart Monitor
Y
BERT Tx State
Telnet Command Line Interface (CLI) Operation
Option Entry
Use the ↑↓ arrow keys to select
• Normal
• Tx CW
• IF Loopback
• RF Loopback
• I/O Loopback
Use the ↑↓ arrow keys to select Disabled, or 10 minutes to 90 minutes
Use the ↑↓ arrow keys to select Loop No Action, Loop RTS Controls
Tx Output, or Ignore RTS Assert CTS
Enter a Circuit ID value as needed
Use the ↑↓ arrow keys to select Off or On
Use the ↑↓ arrow keys to select North or South
Use the ↑↓ arrow keys to select East or West
Enter a value in the form HH:MM:SS
Enter a value in the form DD:MM:YY
Use the ↑↓ arrow keys to select Internal, Tx Terrestrial, Rx Loop
Timed, or Rx Sat
Use the ↑↓ arrow keys to select Rx Satellite, Tx Terrestrial, Internal
SCT, or Insert
Enter a value from 16 to 32768
Use the ↑↓ arrow keys to select:
• Internal
• External 1 MHz
• External 5 MHz
• External 10 MHz
Use the ↑↓ arrow keys to select None, Tx Lock, or Rx Enable
Use the ↑↓ arrow keys to select T1, E1 Balanced, or E1 Unbalanced
Use the ↑↓ arrow keys to select Disable or Enable
Enter a value from 0 to 999 seconds
Use the ↑↓ arrow keys to select No or Yes
Use the ↑↓ arrow keys to select Off or On
9–41
CDM-425 Advanced Satellite Modem
• Tx Alt10 Pattern
• Digital Loopback
• External 2 MHz
• Internal Plus Output
MN-CDM-425
Revision 0
Advertisement
Table of Contents
