CONFIG: IP IP Setup: VLAN PortMode Port#
Where # denotes the selected Port:
Port #: Port Mode= Trunk
Use the ◄ ►arrow keys to select the operation parameter. Then, use the ▲▼ arrow keys to
select Trunk or Access:
•
When you select Trunk as the Port Mode, VLAN ID (PVID) does not apply. On the
bottom line of the display, the selected port's PVID will display as
•
Otherwise, when you select Access as the Port Mode you must configure the VLAN IDs
(PVIDs). Edit the PVID by using the ◄ ►arrow keys to select a digit. Then, use the ▲▼
arrow keys to change that digit, and then press ENTER. You may create a PVID in the
range from 0001 to 4095. The default is 0001.
Hold down the ▲ ▼ arrow keys to quickly scroll between 0001 and 4095.
CONFIG: IP IP Setup: VLAN VLAN-Table
VLAN Table:
View/Edit/Delete
The VLAN table supports up to 32 entries. Use the ◄ ►arrow keys to select View/Edit/Delete or
Add-Entry. Press ENTER.
CONFIG: IP IP Setup: VLAN VLAN-Table View / Edit / Delete
VLAN ID:0001 P1:Filtered
P3:Tagged
Do these steps to view, edit, or delete existing VLAN IDs:
1. Use the ◄ ►arrow keys to select the desired parameter:
•
•
•
Front Panel Operation
PVID=N/A
P4:Untagged
VLAN ID – Selects the tabulated VLAN ID. After selecting VLAN ID, use the ▲▼
arrow keys to scroll through the available VLAN IDs.
ACT – Choose an action to undertake for the selected VLAN ID – NONE
(default), Edit, or Del (Delete).
P1 (Port1) through P4 (Port4) – With ACT=Edit active, you may update the
selected port's behavior attributes, as assigned under the selected VLAN ID.
CDM-425 Advanced Satellite Modem
()
Add-Entry
()
P2:Untagged
ACT=None(N,E,D)
6–62
Revision 0
PVID=N/A
.
MN-CDM-425