Table of Contents
Advertisement
CONFIG: IP IP Setup: VLAN VLAN-Table Add-Entry
VLAN ID:????
P3:Tagged
Do these steps to add new entries to the VLAN table:
1. Use the ◄ ►arrow keys to select the ???? numerical string following the VLAN ID:
parameter.
2. Use the ▲▼ arrow keys to replace the string with a new VLAN ID.
3. Use the ◄ ►arrow keys to select the port (P1/Port1 through P4/Port4), and then use the
▲▼ arrow keys to set the behavior attribute for that port as Tagged, Filtered, or
Untagged.
4. Once you assign the VLAN ID and the port behavior attributes, press ENTER to create
the new entry. The modem then returns you to the previous menu.
Note that:
•
When you attempt to add an entry that is named identically to an existing VLAN ID, you
will see an error message:
ERROR: vid already exists in table
•
When you attempt to add a new entry, and the VLAN table has already reached the 32
maximum allowable entries, you will see an error message:
Can not add new entry!
VLAN table is FULL!
Front Panel Operation
P1:Tagged
P4:Untagged
Hold down the ▲▼ arrow keys to quickly scroll between 1 and 4095.
The port attribute assignment restrictions explained previously apply.
CDM-425 Advanced Satellite Modem
P2:Tagged
ADD ()
6–64
Revision 0
MN-CDM-425
Advertisement
Table of Contents
