Table of Contents
Advertisement
Use the 'Configuration | Modem' page to configure these modem operating parameters:
•
Tx / Rx Interfaces and Framing*
•
Tx / Rx Operating Parameters
*The Tx / Rx Interface Types and Framing Modes have higher priority than other
parameters, and should be configured before setting other parameters.
The page appearances changes with your selection of operating mode. Figure 7-13 shows this
page as it appears when any non-ACM operating mode is active. When IP-ACM or V2-ACM is
selected, an additional area pertinent to IP-ACM (Figure 7-14) or V2-ACM (Figure 7-15) appears
to the right of the Carrier-in-Carrier (CnC) section.
Detailed information on operation and configuration settings is provided elsewhere in this manual.
See Chapter 6. FRONT PANEL OPERATION, Appendix F. D
(C
C) OPTION and Appendix K. V
N
MODULATION (ACM) OPTION.
Click [Submit] to save any changes and settings.
Ethernet-based Remote Product Management
•
Carrier-in-Carrier (CnC) Parameters
•
IP-ACM or VersaFEC-2 ACM
Parameters
FEC/V
FEC-2 ADAPTIVE CODING AND
ERSA
ERSA
7–33
CDM-425 Advanced Satellite Modem
C
-
-C
OUBLETALK
ARRIER
IN
MN-CDM-425
Revision 0
ARRIER
Advertisement
Table of Contents
