Omron CPM2C-S100C Operation Manual page 202

Programming Console Operations
Word Monitor
1,2,3...
Multiple Address
Monitoring
1,2,3...
180
Follow the procedure below to monitor the status of a particular word.
1. Press the CLR Key to bring up the initial display.
2. Input the word address of the desired word.
CH
SHIFT
*
DM
3. Press the MONTR Key to begin monitoring.
The Up or Down Arrow Key can be pressed to display the status of the pre-
vious or next word.
The displayed word's status can be changed using the Hexadecimal/BCD
Data Modification operation. Refer to 8-2-22 Hexadecimal, BCD Data
Modification, 8-2-23 Binary Data Modification, 8-2-24 Signed Decimal
Data Modification, and 8-2-25 Unsigned Decimal Data Modification for de-
tails.
4. Press the CLR Key to end monitoring.
Note The operating mode can be changed without altering the current monitor dis-
play by holding down the SHIFT Key and then changing the operating mode.
The status of up to six bits and words can be monitored simultaneously,
although only three can be shown on the display at any one time.
1. Press the CLR Key to bring up the initial display.
2. Input the address of the first bit or word and press the MONTR Key.
3. Repeat step 2 up to 6 times to display the next addresses to be monitored.
CONT
SHIFT
#
If 4 or more bits and words are being monitored, the bits and words that do
not appear on the display can be displayed by pressing the MONTR Key.
If the MONTR Key is pressed alone, the display will shift to the right.
If more than six bits and words are input, monitoring of the bit or word input
first will be canceled.
4. Press the CLR Key to stop monitoring the leftmost bit or word and clear it
from the display.
00000
B
* CHANNEL LR
EM
1
LR
cL01
FFFF
MONTR
00000
CHANNEL LR
CLR
6
TIM
MONTR
00001 T000
B
^ OFF 0100
MONTR
1
D000000001 T000
0000^ OFF 0100
EM
MONTR
DM
00001 T000
^ OFF 0100
CLR
Section 8-2
01
01