Genie GS-2046 Service Manual page 81

June 2003
REV A
18 Move the scissor assembly towards the non-
steer end of the machine slightly and to one
side of the machine until one of the scissor arm
wear pads is accessible. Do not allow both
wear pads to slide out of the drive chassis.
Crushing hazard. The scissor
assembly will fall if both wear pads
are allowed to slide out of the drive
chassis.
19 Install the new wear pad.
Note the position of the wear pad
before it is removed so when the
new one is installed it will be in the
correct position.
20 Move the scissor assembly towards the other
side of the machine until the other scissor arm
wear pad is accessible.
Crushing hazard. The scissor
assembly will fall if both wear pads
are allowed to slide out of the drive
chassis.
21 Install the new wear pad.
Note the position of the wear pad
before it is removed so when the
new one is installed it will be in the
correct position.
22 Slide the scissor assembly back into the drive
chassis.
Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246
Section 4 • Repair Procedures
23 Lower the scissor assembly into position and
install the pivot pins.
Component damage hazard. Be
careful not to damage the level
sensor box, limit switch or level
sensor while installing the scissor
assembly.
SCISSOR COMPONENTS
4 - 41