Genie GS-2046 Service Manual page 93

June 2003
REV B
51 Place a 1.57 x 6 x 6 inch / 25 mm x
15 cm x 15 cm thick steel block under both
wheels at the battery pack side of the machine.
52 Lower the machine onto the blocks.
53 Models before serial number 48817: Raise
the platform 7 to 8 feet / 2.1 to 2.1 m.
Result: The tilt sensor alarm should sound.
Result: If the tilt sensor alarm does not sound,
adjust the tilt level sensor until the alarm just
begins to sound OR the down limit switch may
need to be adjusted.
CE models: When the platform is
raised 7 to 8 feet / 2.1 to 2.4 m
from the ground, an alarm should
sound and the lift and drive
functions should not operate.
Models after serial number 48816: Raise the
platform 7 to 8 feet / 2.1 to 2.4 m.
Result: The platform should stop and an alarm
should sound.
Result: If the platform does not stop or the tilt
sensor alarm does not sound, adjust the tilt
level sensor until the alarm just begins to sound
OR the down limit switch may need to be
adjusted.
54 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246
Section 4 • Repair Procedures
55 Lower the scissor arms onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
56 Install the tilt level sensor box cover.
57 Raise the platform slightly.
58 Return the safety arm to the stowed position.
59 Lower the platform to the stowed position.
60 Raise the machine approximately
2 inches / 5 cm.
61 Remove the blocks from under both wheels.
62 Lower the machine and remove the jack.
GROUND CONTROLS
4 - 53