Genie GS-2046 Service Manual page 77

June 2003
REV A
47 Remove the mounting fasteners from the lower
cable tray supports.
48 Remove the external snap rings from the
number 2 center pivot pin (index #11) at the
ground controls side. Do not remove the pin.
49 Slide the cable tray towards the battery pack
side of the machine and remove it from the
machine.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
50 Attach a lifting strap from an overhead crane to
the lug on the rod end of the lower lift cylinder.
51 Remove the pin retaining fasteners from the
lower lift cylinder rod-end pivot pin (index #9).
Use a soft metal drift to remove the pin.
52 Lower the cylinder onto the number 1 center
pivot pin (index #13).
Crushing hazard. The cylinder
may become unbalanced and fall
when it is lowered if it is not
properly attached to the overhead
crane.
53 Attach a lifting strap from an overhead crane to
the number 3 inner arm (index #24).
54 Remove the external snap rings from the
number 3 pivot pin (index #10).
Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246
Section 4 • Repair Procedures
55 Use a soft metal drift to remove the number 3
pivot pin (index #10). Remove the number 3
inner arm (index #24) from the machine.
Bodily injury hazard. The number
3 inner arm (index #24) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
56 Attach a lifting strap from an overhead crane to
the number 2 outer arm (index #27) at the
ground controls side.
57 Use a soft metal drift to remove the number 2
center pivot pin (index #11) at the ground
controls side.
58 Remove the external snap rings from the
number 2 pivot pin (index #28) at the non-steer
end of the machine. Do not remove the pin.
59 Use a soft metal drift to tap the number 2 pivot
pin (index #28) halfway out at the non-steer end
of the machine. Remove the number 2 outer
arm (index #27) from the ground controls side
of the machine.
Bodily injury hazard. The number
2 outer arm (index #27) at the
ground controls side may become
unbalanced and fall if not properly
supported when it is removed from
the machine.
60 Attach a lifting strap from an overhead crane to
the number 2 outer arm (index #27) at the
battery pack side.
SCISSOR COMPONENTS
4 - 37