Genie GS-2046 Service Manual page 74

Section 4 • Repair Procedures
SCISSOR COMPONENTS
12 Attach a lifting strap from an overhead crane to
the lug on the rod end of the upper lift cylinder.
13 Remove the pin retaining fasteners from the
upper cylinder rod-end pivot pin (index #3). Use
a soft metal drift to remove the pin.
Crushing hazard. The cylinder
may fall if not properly supported
when the pin is removed.
14 Lower the cylinder onto the number 3 center
pivot pin (index #8).
15 Attach a lifting strap from an overhead crane to
the number 5 inner arm (index #17).
16 Remove the external snap rings from the
number 5 pivot pin (index #4).
17 Use a soft metal drift to remove the number 5
pivot pin (index #4). Remove the number 5
inner arm (index #17) from the machine.
Bodily injury hazard. The number
5 inner arm (index #17) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
18 Remove the external snap rings from the
number 4 center pivot pin (index #5) at the
ground controls side.
19 Remove the external snap rings from the
number 4 center pivot pin (index #5) at the
battery pack side.
20 Use a soft metal drift to remove both of the
number 4 center pivot pins (index #5).
4 - 34 Genie GS-2046 and GS-2646 and GS-3246
21 Remove the external snap rings from the
number 4 pivot pin (index #22) at the non-steer
end of the machine.
22 Use a soft metal drift to remove the number 4
pivot pin (index #22). Remove the number 4
outer arm (index #21) from the machine.
Bodily injury hazard. The number
4 outer arm (index #21) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
23 Attach a lifting strap from an overhead crane to
the number 4 inner arm (index #20).
24 Remove the external snap rings from the
number 4 pivot pin (index #6) from the steer
end of the machine.
25 Use a soft metal drift to remove the number 4
pivot pin (index #6). Remove the number 4
inner arm (index #20) from the machine.
Bodily injury hazard. The number
4 inner arm (index #20) may
become unbalanced and fall if not
properly supported when it is
removed from the machine.
26 Remove the safety arm from the number 4 inner
arm (index #20) that was just removed.
June 2003
REV A
Part No. 72972