Genie GS-2046 Service Manual page 51

June 2003
REV B
Software revision C0:
1 Push in the red Emergency Stop button to the
off position at the ground and platform controls.
Turn the key switch to the off position.
2 Pull out the red Emergency Stop button to the
on position at the ground and platform controls.
3 Press and hold the lift function select and horn
buttons, and turn the key switch to platform
controls.
Result: The diagnostic display will show "PS".
a function enable switch SW5
b joystick controller JC1 with thumb
steering rocker SW6
c horn button BN5
d machine on incline button
e lift function select button BN9
f drive function select BN8
g red Emergency Stop button P2
4 Release the lift function select and horn
buttons.
Result: The diagnostic display will show the
maximum lift speed percentage.
5 Press the drive function select button.
Result: The diagnostic display will show "PS."
Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246
Section 4 • Repair Procedures
6 Press and hold the horn button.
Result: The diagnostic display will show the
raised drive speed percentage.
7 Use the steering thumb rocker switch on the
joystick to increase or decrease the maximum
lift speed percentage. Refer to Section 2,
Specifications .
8 Turn the key switch to the off position.
Any change in software settings
will not take effect until the key
switch is turned to the off position.
PLATFORM CONTROLS
4 - 11