Genie GS-2046 Service Manual page 66

Section 4 • Repair Procedures
SCISSOR COMPONENTS
13 Use a soft metal drift to remove the number 4
pivot pin (index #3) at the steer end. Remove
the number 4 inner arm (index #13) from the
machine.
Crushing hazard. The number 4
inner arm (index #13) may
become unbalanced and fall if not
properly supported when it is
removed.
14 Attach a lifting strap from an overhead crane to
the number 3 outer arm (index #4) at the
ground controls side.
15 Remove the external snap rings from the
number 3 center pivot pin (index #17).
16 Use a soft metal drift to remove the number 3
center pivot pin (index #17).
17 Remove the external snap rings from the
number 3 pivot pin (index #18) at the non-steer
end of the machine. Do not remove the pin.
18 Use a soft metal drift to tap the number 3 pivot
pin (index #18) halfway out at the non-steer end
of the machine. Remove the number 3 outer
arm (index #4) at the ground controls side from
the machine.
Bodily injury hazard. The number
3 outer arm (index #4) at the
ground controls side may become
unbalanced and fall if not properly
supported when it is removed from
the machine.
19 Attach a lifting strap from an overhead crane to
the number 3 outer arm (index #4) at the
battery pack side.
4 - 26 Genie GS-2046 and GS-2646 and GS-3246
20 Use a soft metal drift to tap the number 3 pivot
pin (index #18) in the other direction. Remove
the number 3 outer arm (index #4) from the
battery pack side of the machine.
Bodily injury hazard. The number
3 outer arm (index #4) at the
battery pack side may become
unbalanced and fall if not properly
supported when it is removed from
the machine.
21 Remove the number 3 pivot pin (index #18)
from the non-steer end of the machine.
22 Attach a lifting strap from an overhead crane to
the lug on the rod end of the lift cylinder for
support. Do not lift it.
23 Remove the pin retaining fasteners from the lift
cylinder rod-end pivot pin (index #5). Use a soft
metal drift to remove the pin.
Bodily injury hazard. The cylinder
may fall when the rod-end pivot
pin is removed if it is not properly
supported.
24 Lower the cylinder onto the number 1 center
pivot pin (index #9).
25 Remove the cables from the number 3 inner
arm (index #16) and lay them to the side.
26 Attach a lifting strap from an overhead crane to
the number 3 inner arm (index #16).
27 Remove the external snap rings from the
number 3 pivot pin (index #6) at the steer end.
June 2003
REV A
Part No. 72972