Genie GS-2046 Service Manual page 92

Section 4 • Repair Procedures
GROUND CONTROLS
29 Center a lifting jack under the drive chassis at
the non-steer end of the machine.
30 Raise the machine approximately
5 inches / 13 cm.
31 Place a 6.63 x 6 x 6 inch / 12.1 x 15 x 15 cm
thick steel block under both wheels at the
non-steer end of the machine.
32 Lower the machine onto the blocks.
33 Models before serial number 48817: Raise
the platform 7 to 8 feet / 2.1 to 2.1 m.
Result: The tilt sensor alarm should sound.
Result: If the tilt sensor alarm does not sound,
adjust the tilt level sensor until the alarm just
begins to sound OR the down limit switch may
need to be adjusted.
CE models: When the platform is
raised 7 to 8 feet / 2.1 to 2.4 m
from the ground, an alarm should
sound and the lift and drive
functions should not operate.
Models after serial number 48816: Raise the
platform 7 to 8 feet / 2.1 to 2.4 m.
Result: The platform should stop and an alarm
should sound.
Result: If the platform does not stop or the tilt
sensor alarm does not sound, adjust the tilt
level sensor until the alarm just begins to sound
OR the down limit switch may need to be
adjusted.
34 Lower the platform to the stowed position.
4 - 52 Genie GS-2046 and GS-2646 and GS-3246
35 Raise the machine approximately
5 inches / 13 cm.
36 Remove the blocks from under both wheels.
37 Lower the machine and remove the jack.
38 Remove the blocks from the wheels at the steer
end of the machine.
39 Center a lifting jack under the drive chassis at
the ground controls side of the machine.
40 Raise the machine approximately
2 inches / 5 cm.
41 Place a 1.36 x 6 x 6 inch / 21.5 mm x
15 cm x 15 cm thick steel block under both
wheels at the ground controls side of the
machine.
42 Lower the machine onto the blocks.
43 Raise the platform 7 to 8 feet / 2.1 to 2.4 m.
Result: The tilt sensor alarm should sound.
44 Adjust the tilt level sensor retaining fasteners
just until the tilt sensor alarm does not sound.
45 Lower the platform to the stowed position.
46 Raise the machine approximately
2 inches / 5 cm.
47 Remove the blocks from under both wheels.
48 Lower the machine and remove the jack.
49 Center a lifting jack under the drive chassis at
the battery pack side of the machine.
50 Raise the machine approximately
2 inches / 5 cm.
June 2003
REV B
Part No. 72972