Genie GS-2046 Service Manual page 117

June 2003
REV B
9 Activate the platform up function.
Result: The power unit should not be able to lift
the platform.
Result: If the power unit lifts the platform,
remove the additional weight and repeat steps
4 through 9.
Tip-over hazard. Do not adjust the
relief valve to allow the power unit
to lift more than maximum rated
load.
Component damage hazard. If the
pump cavitates or platform fails to
reach full height, add hydraulic oil
until the pump is functioning
correctly. Do not overfill the
hydraulic reservoir.
10 Remove the weight from the platform.
11 Bleed the hydraulic system. Raise the platform
to full height and then lower it to the stowed
position through two complete cycles.
Component damage hazard. Do
not continue to operate the
machine if the hydraulic pump is
cavitating. If the pump is still
cavitating, see 5-1, How to test the
Hydraulic Pump.
Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246
Section 4 • Repair Procedures
MANIFOLDS
4 - 77