Genie GS-2046 Service Manual page 46

Section 4 • Repair Procedures
PLATFORM CONTROLS
How to Adjust the Lift Speed
Tip-over hazard. Do not adjust the
lift and/or drive speed higher than
specified in this procedure. Setting
the drive speed greater than
specifications will cause death or
serious injury.
Tip-over hazard. This procedure
must only be performed by a
trained service professional.
Attempting this procedure without
the necessary skills will result in
death or serious injury.
Software revision A0 and B0:
1 Push in the Emergency Stop button to the off
position at the ground and platform controls.
Turn the key switch to the off position.
2 Pull out the Emergency Stop button to the on
position at the ground and platform controls.
4 - 6 Genie GS-2046 and GS-2646 and GS-3246
3 Press and hold the lift function enable and horn
buttons, and turn the key switch to platform
controls.
Result: The diagnostic display will show "PS."
a function enable switch SW5
b joystick controller JC1 with thumb
steering rocker SW6
c horn button BN5
d machine on incline button BN6
e lift function enable button BN9
f red Emergency Stop button P2
4 Release the lift function enable and horn
buttons.
5 Press and hold the lift function enable button.
Result: The diagnostic display will show the
maximum lift speed percentage.
6 Use the steering thumb rocker switch on the
joystick to increase or decrease the maximum
lift speed percentage. Refer to Section 2,
Specifications .
7 Turn the key switch to the off position.
Any change in software settings
will not take effect until the key
switch is turned to the off position.
June 2003
REV B
Part No. 72972