Appendix A-1-5 Cautions On Using Transparent (2-Port) Function Of Got-F900 Series - Mitsubishi Electric MELSEC FX3U Programming Manual

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
Appendix A-1-5 Cautions on using transparent (2-port) function of
GOT-F900 Series
Make sure to provide the following setting when monitoring circuits, device registration, etc. in an FX
FX PLC using GX Developer Ver. 8.13P or later (Ver. 8.72A or later in an FX
3UC
(2-port) function of the GOT-F900 Series.
If the following setting is not provided, monitoring cannot be normally executed .
When using
transparent function in
GOT-F900 Series
When directly
connecting GX
Developer to PLC
(standard built-in RS-
422 port)
*1. GX Developer Ver.8.13P or later supports the FX
*2. GX Developer Ver.8.72A or later supports the FX
Setting in GX Developer Ver. 8.13P or later (Ver. 8.72A or later in FX
1. Select [Online] → [Transfer setup...] to open "Transfer Setup" dialog box.
2. Double-click [PLC module] in [PLC side I/F] to open [PLC side I/F Detailed setting of PLC
module] dialog box.
3. Put a check mark in the check box [via GOT-F900 transparent mode] as shown below.
4. Click [OK] button to finish the setting.
GX Developer
*1
Ver.8.12N or earlier
Setting shown below is
not required.
Set "COM port" and "Transmission speed" on "PC
side I/F Serial setting" dialog box.
Double-click it.
A Programming Tool Applicability and Version Upgrade History
GX Developer
GX Developer Ver.8.22Y or later
Ver.8.13P or later
Select "RS-232C" on "PC side I/F Serial
Setting shown below is
setting" dialog box, and execute settings
required.
shown below.
Select "RS-232C" on "PC side I/F Serial
setting" dialog box, and set "COM port" and
"Transmission speed".
Series.
3UC
Series.
3G
Put a check mark in the
check box "via GOT-F900
transparent mode".
A-1 Programming Tool Applicability
/FX
3G
PLC) and the transparent
3G
*2
PLC)
3G
955
31
/
3U
32
33
34
35
36
37
38
A
B