Mitsubishi Electric MELSEC FX3U Programming Manual page 274

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
• When a constant (K) is specified as the transfer source
Command
input
FNC 16
2. 32-bit operation (DFMOV and DFMOVP)
The contents of [
• The contents will be the same among all of "n" 32-bit devices.
• If the number of points specified by "n" exceeds the device number range, data is transferred within the
possible range.
• While the command input is OFF, the transfer destination [
• While the command input is ON, the data of the transfer source [
• When a constant (K) is specified as the transfer source [
binary.
X000
FNC 16
DFMOV
S
272
S D
FMOV
S
+1, ] are transferred to "n" 32-bit devices starting from [
S S
S D
S
+1,
, it is automatically converted into binary.
S
n
D
D +1
n
D +2
D +3
D +4
+1,
D
+1,
S
n
D D
+1,
D D
+3, +2
n
D D
+5, +4
D +7, D +6
D +9, D +8
9 Move and Compare – FNC 10 to FNC 19
9.7 FNC 16 – FMOV / Fill Move
+1,
D
] does not change.
D
+1, ] does not change.
S S
], it is automatically converted into
S
].
D