FX
Series Programmable Controllers
3S
User's Manual - Hardware Edition
5.5
Cautions on using transparent port (2-port) function of GOT-F900
Series
When monitoring circuits, device monitor, etc. in an FX
function in the GOT-F900 Series, make sure to execute the following setting.
1. Double-click the Connection Destination view → [Connection Destination] → [(Connection
target data name)] in the Navigation window of GX Works2.
The [Transfer Setup Connection1] is displayed.
2. Double-click [Serial USB] of the PC side I/F to display [PC side I/F Serial Setting].
3. Select [RS-232C] in setting shown below, and set [COM port] and [Transmission Speed].
4. Double-click [GOT] of the PLC side I/F to display [PLC side I/F Detailed Setting of GOT].
5. Select [FXCPU], [via GOT[direct coupled] transparent mode] in setting shown below and put
a check mark to the check box [via GOT-F900 transparent mode] .
6. Click the [OK] button to finish the setting.
5.5 Cautions on using transparent port (2-port) function of GOT-F900 Series
Double-click it.
5 Version Information and Peripheral Equipment Connectability
PLC from GX Works2 using the transparent (2-port)
3S
Select [FXCPU]
Select [via GOT[direct coupled] transparent mode]
Put a check mark to the check box
[via GOT-F900 transparent mode]
1
2
3
4
5
6
7
8
9
10
47