Table of Contents
Advertisement
RUD to AIL
This function is used when you want to mix
the ailerons with rudder operation. It is used
when rudder is applied during roll maneuvers,
knife edge, etc. of stunt planes. It can be used to
bank scale models, large models, etc. like a full
size plane.
by using the memory function. This is convenient
operation (switch operation) is performed in the
memory mode with correction rudder applied, the
switch operation position at that time is displayed
call the setup screen shown below.
memory items are displayed.
to call the <Switch> screen, and then select the
(For a description of the switch selection method,
see the description at the back of this manual.)
button to call the <Switch> screen and then select
direction can be set,.
method, see the description at the back of this
manual.)
(For a description of the curve setting method,
see the description at the back of this manual.)
exited, the memorized points are automatically
selected.)
mixings.
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 1
Winglet
(
)
at Flying wing
V-TAIL
RUDDER 2
RUDDER
(For a description of the curve setting method, see the
description at the back of this manual.)
(Example) Using the memory function with an F3A
airplane (knife edge correction)
*When call switch
[SW-A] and memory switch
[SW-H] were set
while performing aileron correction when rudder
was applied at knife edge, the point position at
that time is memorized. Perform memorization while
changing the left and right stick positions.
curve, and operation is simultaneously set.
the memory SW is not accidentally set to ON and incorrect
mixing setting is not applied when taxiing, starting the engine,
etc.
<Model Menu (Airplane/Glider Functions)>
AIL 2
(Main Aileron)
AIL 3
(Chip Aileron)
RUDDER 2
Winglet
(
)
at Flying wing
RUDDER
adjustment by
89
Advertisement
Table of Contents
